- PROFIBUS-DP slave acc. to IEC 61158 (240 bytes input and 240 bytes output)
- CANopen Manager
- Cycle time only limited by PROFIBUS-DP
- Cable-free connection of esd CAN-CBX I/O modules to the gateway
- InRailBus for CAN connection and power feed
The CANopen-DP/2 can link any PROFIBUS-DP master to a CANopen network. The gateway operates as a PROFIBUS-DP slave-I/O component with a total of maximum 240 bytes input and 240 bytes output data. It supports cyclic (DP-V0) as well as acyclic (DP-V1) PROFIBUS data transfers. On the CANopen side it operates as a CANopen manager supporting NMT master and configuration functions. PDO and SDO (with SDO timeout and MPDO transmission) data transfers are supported. START frame, SYNC and Heartbeat are controlled by the module.
With the CANopen-DP/2 gateway you can couple CANopen modules e.g. to a SIMATIC-S7. The number of CANopen devices is not limited by the module.
The ISO 11898-compatible CAN interface allows a maximum data-transfer rate of 1 Mbit/s. The PROFIBUS-DP-Slave interface automatically recognizes all usual bit rates up to 12 Mbit/s. The PROFIBUS-DP as well as the CAN interface are electrically isolated.
The module can be configured via PROFIBUS configuration tool, e.g. the PLC SIMATIC Manager. CANopen is supported as CAN-layer-7 protocol on the CAN layer. Additionally CAN-layer-2 functions are available.
CANopen-DP/2 Gateway CANopen auf PROFIBUS-DP Slave Datenblatt (EN)
Gateway CANopen to Profibus-DP slave
Operating voltage: typ. 24VDC
ARM Cortex M3 microcontroller
with integrated CAN-Controller,
CAN physical layer ISO 11898-2,
up to 1 MBit/s, galv. isolation
VPC3 Profibus-DP slave controller
DP physical layer: RS-485,
up to 12 MBit/s, galv. isolation
Firmware with gateway function
Manual and GSD file on CD-ROM
- galvanically isolated
- CANopen Manager
- CAN-Layer 2