CAN-CBX-Pt100

CANopen® Module with 4 RTD Inputs

High Resolution Temperature Measurement

  • 4 temperature sensor (RTD) inputs

  • Two- or four-wire connection

  • Resistance measurement

  • Selectable resolution of sensor resistor inputs: 0.1 °C ... 0.0001 °C

  • CANopen profiles acc. to CiA® specification CiA 301 and CiA 404

Approved Reliability and Ease of Use

  • Electrical isolation of temperature sensor inputs: all channels are electrically isolated against the microcontroller circuits and against each other

  • InRailBus technology combines high ease of use and proven reliability

  • DIN-EN carrier rail mounting (TS 35)

Extensive Setup Options of RTD Channels

  • Selectable sample rates: 2.5 ... 1000 SPS

  • Wide range of supported sensor types: Pt100, Pt200, Pt500, Pt1000, Pt5000, Ni100, Ni200, Ni500, Ni1000 and Ni5000

  • Linearisation according to NIST by on board microcontroller

  • Offset/Gain can be adjusted by the user

RTD - Resistance Temperature Device Inputs

The CAN-CBX-Pt100 is designed for the direct connection of up to four temperature sensors. Simple resistance measurements can also be performed. Pt- and Ni-resistance sensors are supported. The sensor resistors can be connected in two- or four-wire configuration. The conversion of the four sensor resistor inputs is realized by four independent ΣΔ-converters. Linearisation according to NIST is achieved by the on board microcontroller.

CAN Interface and LED Display

The CAN interface is designed according to ISO11898-2 high-speed layer with electrical isolation and supports bit rates up to 1 Mbit/s. The CANopen-node number and the CAN bit rate can be easily set via coding switches. Four LEDs indicate the module and CANopen node status.

InRailBus

The CAN-CBX-PT100 features the possibility to connect the power supply and the CAN bus signals via the InRailBus connector (TBUS-connector) integrated in the mounting rail. Individual modules can then be removed from the InRailBus without interrupting the bus signals.

Software Support

The module comes with CANopen firmware according to CiA 301and supports the CiA 404 profile for measuring devices.

CANopen IO module with RTD inputs by esd