Dual Ethernet PMC Module


  • 2 Ethernet ports

  • 100BASE-TX (IEEE802.3)

  • Full duplex operation

  • Automatic speed configuration

  • 33/66 MHz PCI bus speed

  • Runs with standard Ethernet system drivers of Linux® and VxWorks®

PMC Board Specifications
The PMC-ETH2 is a PMC target board in ‘single’ PCI Mezzanine Card size. The PCI to PCI bridge enables the board to run at 33 MHz and 66 MHz PCI bus clock rate. According to the clock rate the module is tolerant for 3.3 V signal or 5 V signal voltage. The supply voltages has to be 3.3 V and 5 V.

Ethernet Interfaces
The PMC-ETH2 comes with two Ethernet ports for 10 Mbit/s and 100 Mbit/s nets. Full duplex operation is supported for both speeds. The ports are accessible as 10/100BaseT (IEEE 802.3) via RJ45 connectors in the front panel. Each channel is equipped with its own Ethernet controller with integrated DMA, FIFO and PCI bus interface.
Four LEDs for each Ethernet port show the modules state at the front panel.

Software Support
The module runs with the standard Ethernet system drivers of Linux® and VxWorks®. Please ask for your operating system support.

Dual Ethernet PMC Module by esd: PMC-ETH2
End of life